Table of Contents
Advertisement
4
Remove the two panels shown in Figure 2-11 and follow 5.4 Wiring to perform wiring.
After wiring, reinstall the two panels.
5
To prevent possible damage from rodents, please take the provided six rodent shields
(including 22 M4 screws) out of the accessory package and install them on the UPS.
The provided rodent shields have four types, A, B, C and D. Each of type A and type B
has two pieces, and each of type C and type D has one piece.
1. Follow Figure 6-4 to install a rodent shield A and a rodent shield B at the front
2. Follow Figure 6-5 to install the other rodent shield A and the other rodent shield B
Ultron DPS Series
bottom of the UPS.
M4
Screw
Rodent Shield A
(M4 Screw x 4)
(Figure 6-4: Install the Rodent Shields A & B at the Front of the UPS)
at the rear bottom of the UPS.
M4
Screw
Rodent Shield A
(M4 Screw x 4)
(Figure 6-5: Install the Rodent Shields A & B at the Rear of the UPS)
(Front View)
INPUT SWIT
CH
BYPA SS SWIT
CH
MANU AL
BYPA SS SWIT
CH
RISK OF
BEFORE
WORKING
VOLTAGE
BACKFEED
Isolate Uninterruptible
ON THIS
CIRCUIT
Then check
terminals
for Hazardous
Power System
(UPS)
See installation
including
the protective
Voltage between
all
Apparatet
er egnet for
instructions
before connecting
earth
tilkopling
til et IT forsyningsnett
to the supply
(Rear View)
6-6
OUT PUT
SWIT CH
Rodent Shield B
(M4 Screw x 4)
Rodent Shield B
(M4 Screw x 4)
Advertisement
Table of Contents
