Avery Dennison snap 700 Operator's And Service Manual page 104

104
5. Create a sub-assembly of the Plastic Collet, the Fiber Optic Slide Shaft, The Fiber Optic
Cable and the O-Ring.
6. From the back of the Upright Frame, slide the Collet / Cable Assembly through the ¾
diameter hole and secure with (2) 10-32 x 3/8 Button Head Screws.
10-32 X 3/8 Button
Head Screws
Classification: Avery Dennison - Public
Slide the two cables at the rear of the Fiber-Optic Assembly through the Collet as
shown. This must be done by sliding one cable through, then sliding cable end
of the other cable through parallel to the first. They will not go through together.
COLLETT
FIBER-OPTIC CABLE
User's Manual—SNAP™ 700 Printer
SLIDE SHAFT
"O" RING