Communications Settings; Setting Ecm Sending (Ecm Tx) - Canon IR3250 Reference Manual

Super g3 fax board-h1

Hide thumbs Also See for IR3250:

Table of Contents

Communications Settings

This section describes settings necessary for sending and receiving faxes.

You can send faxes in ECM mode. ECM is a function that automatically corrects errors in image

transmission.

NOTE

• The factory setting is On.

• ECM is an acronym for Error Correction Mode.

• ECM transmission requires that both the sending and receiving devices be set for ECM. (If this setting is

not made at both ends, this function is not valid.)

• Even when the ECM function is set, errors can be caused by telephone line problems.

• When telephone line problems are present, transmissions may require more time.

Call up the desired screen as follows:

Additional

key → [Communications Settings] → [Fax Settings] → [ECM TX]

Functions

Select [On] or [Off], then press the [OK] key.

Press the [Done] key.

Repeat until the Additional Functions screen closes.

4-24

Table of Contents