94
Lights and visibility
Windscreen washers
Front windscreen wipers
The windscreen wiper lever controls the windscreen wipers
and the automatic wash and wipe.
The windscreen wiper lever
Switching off the wipers
– Move the lever to position
Intermittent wipe
– Move the lever up to position
Fig. 64 Windscreen wiper
and windscreen wash
lever
⇒ fig. 64
has the following positions:
A
.
0
A
.
1
A
– Move the control
to the left or right to set the length of the
A
intervals. Control to the left - longer wipe pause, control to the
right - shorter wipe pauses. Four wiper interval stages can be set
A
using switch
.
A
Slow wipe
– Move the lever up to position
Continuous wipe
– Move the lever up to position
Brief wipe
– Move the lever down to position
wipe.
Wash and wipe automatic system
– Pull the lever towards the steering wheel - Position
screen washer is activated.
– Then release the lever. The wipers-washers will keep running for
approximately four seconds.
The windscreen will be wiped again after approximately five seconds once the
wipe/wash system has been operated.
WARNING
•
Worn and dirty wiper blades obstruct visibility and reduce safety levels.
•
In cold conditions, you should not use the wash / wipe system unless
you have warmed the windscreen with the heating and ventilation system.
The washer fluid could otherwise freeze on the windscreen and obscure
your view of the road.
A
.
2
A
.
3
A
to give the windscreen a brief
4
A
, the wind-
5