Service, Maintenance And Care - Taski swingo XP Instructions Of Use

Cleaning the machine
Caution:
Never clean the machine with high water pressure or a water
hose.
The ingress of water into the machine might cause considerable
damage to mechanical or electrical parts.
• Switch the machine off using the keyswitch and remove the key.
• Wipe down the machine with a damp cloth.
Storage / parking of machine (machine is idle)
• Switch the machine off using the keyswitch and remove the key.
• Press the Emergency Stop button.
Store the machine with the lid slightly open.
This allows the tank to dry out. As a result, the formation of mould and
unpleasant smells can be reduced.

Service, maintenance and care

Caution:
Only TASKI branded spare parts must be used, otherwise
warranties and liabilities will be omitted!
The machine's maintenance is pre-condition for trouble-free running and a long
life.
Symbols:
◊ = After use, ◊◊ = Every week, ◊◊◊ = Every month,
⊗ = Service light
Activity
Recharge batteries
Clean all parts marked yellow
Drain and clean the recovery tank
Empty and clean the Flex tank
Check the dirt sieve for residual matter, and clean
if necessary
Check solution supply pipe and filter and clean if
necessary
Check the vacuum air filter for dirt, and clean if
necessary
Cleaning the tools
Clean squeegee, check whether the blades are
worn and replace if necessary
Wipe down the machine with a damp cloth
Clean the tank lid seal, check for cracks and re-
place if necessary
Maintenance programs by TASKI service made by
TASKI technician
Service intervals
TASKI machines are built to the highest quality standards. This is supported by
internationally recognised quality control procedures. Electrical and mechanical
parts are subject to wear or aging if used for long periods of time.
Under rough or extreme working conditions and / or insufficient maintenance,
shorter intervals may be necessary.
Service centre
Should you contact us due to a malfunction or for placing an order, please
always state the type, description and the serial number of your machine.
You can find this information on the name plate of your machine, and the
address of your nearest TASKI partner can be found on the last page of this
manual.
Blades replacement
• Lay the clean squeegee body on a firm surface (table, floor etc) with the
blades facing upwards.
• Evenly loosen the four Allen screws until the clamping device becomes
loose (do not fully screw out ther Allen screws).
• Pull out the blades, and either turn or replace them.
• Push the blades back into the slots, and then firmly retighten the clamp at
the bottom with the allen screws.
◊ ◊◊ ◊◊◊ ⊗ page
39
42
42
42
42
42
42
42
43
44
• In order to ensure operational reliability and
availability for use, the service must be carried
out when the service indicatior lights up (factory
setting 650 working hours) or at least once a
year.
Note the markings in the middle of the blades and the squeegee!
The markings on the squeegee and the blades must agree.
43