Service, Maintenance And Care; Transport; Disposal; Malfunctions - Taski jet 38 Instructions Of Use

Service, maintenance and care

Caution:
Only TASKI branded spare parts must be used, otherwise
warranties and liabilities will be omitted!
The correct maintenance of the machine is a precondition for a flawless
operation and a long service life.
Symbols:
◊ = after use, ◊◊ = every week, ◊◊◊ = every month
Activity
Check double-filter paper bag, replace if necessary
Clean the tool (roller brush, etc.)
Periodically check the length of the bristles
Replace the exhaust air filter for the electrical suction
brush
Replace the waste air filter for the suction unit
Replace the motor protection filter
Clean the machine with a damp cloth
Service intervals
TASKI machines are built to the highest quality standards, and are tested for
safety in the factory and by authorised inspectors. Electrical and mechanical
parts are subject to wear or aging if used for long periods of time.
• To maintain functional safety and operational readiness, a service must be
carried out after 300 working hours or at least once a year.
Under rough or extreme working conditions and/or insufficient maintenance,
shorter periods may be necessary.
Service centre
Should you contact us due to a malfunction or for placing an order, please
always state the type, description and the serial number of your machine.
You can find this information on the name plate of your machine, and the
address of your nearest TASKI partner can be found on the last page of this
manual.

Transport

Ensure that the machine is securely fastened within the transportation vehicle.

Disposal

When it has reached the end of its operational life, the machine and its
accessories must be disposed of according to the national regulations.

Malfunctions

Malfunction Possible causes
Not turned on
Power supply cord not
properly plugged into
the mains socket
Machine does not Power supply cord
run defect
Motor defect
Main switch defect
Machine not in the
working position
Electrical suction
brush does not
Motor runs but not the
turn
brush
◊ ◊◊ ◊◊◊ page
23
24
24
24
24
24
24
Troubleshooting page
• Turn on 22
• Check
• Call for technical
assistance
• Call for technical
assistance
• Call for technical
assistance
• Place the machine in
22
the working position
• Drive defective
• Call for technical
assistance
Malfunction Possible causes
Motor protection filter
dirty
Suction hose or
squeegee nozzle
blocked
Double-filter paper
Poor vacuum
bag full.
performance
Cover of the suction
unit not correctly fitted
Suction hose not con-
nected
Accessory not cor-
rectly fitted
Damp double-filter
paper bag
Build-up of
odours
Accumulation of mois-
ture

Technical data

Name jet 38
type TR5.38
Rated voltage 220-240 V
100-120 V
Frequency 50-60
Rated power 900
Machine weight 7.8
Dimensions (L x W x H) 26x38x120
A-weighted emission sound <70
pressure level EN 60704-1
Electrical protection class II

Accessories

Article
8502160 Double-filter paper bag (Pack of 10 units)
8503640 Motor protection filter (Pack of 10 units)
4121380 Exhaust air filter for electrical suction brush
8505110 Exhaust air filter for suction unit
8505180 Hepa filter (optional)
Troubleshooting page
• Clean or replace motor
24
protection filter
• Remove the blockage
• Replace
23
• Check
• Check
• Check
• Store in a dry room
24
• Change double-filter
23
paper bag or drain tub
jet 50
TR5.50
220-240 V AC
AC
100-120 V
50-60 Hz
920 W
8.3 kg
26x50x120 cm
<70 dB(A)
II
jet 38/50
X
X
X
X
X
25