Advertisement
End of operation
• Release the switching lever left and / or right.
• By tilting back the machine, a support wheel is
lowered underneath the machine.
Relieving the tool.
• Press the foam generator switch.
Empty foam solution
The disposal of the foam solution must be carried out in accordance with
national regulations.
• Drive the machine to a drain.
• First open the tank lid and then the vent opening
1
/ filter.
The tank lid must always be removed, otherwise
a vacuum will arise, which will result in the tank
only emptying slowly.
2
Cleaning the foam solution tank and Cleaning the vent opening / filter
• Throughly clean the foam solution tank and the filter with lukewarm water.
• Refit the solution filter.
Caution:
Clogged filters reduce the flow of the cleaning solution. As a
consequence you may damage the floor coating.
Cleaning the tools
Caution:
The tank must be emptied before removing the tool!
• Pull the handle adjustment lever and slowly lift
the handle until it is in the upright position.
2
1
Lock the adjustment lever again.
• Tilt back the machine until the handle rests on
the floor.
• Pull the brush locking device outwards and
hold, remove the tool.
1
• Clean the squeegee under running water with a
brush.
2
• Pull and hold the brush locking device and
press the tool back into position.
1
Move the tool to ensure that it is latched in.
2
20
• Slowly return the machine to its upright position.
Cleaning the machine
• Wipe down the machine with a damp cloth.
Caution:
Never clean the machine with high water pressure or a water
hose.
The ingress of water into the machine might cause considerable
damage to mechanical or electrical parts.
Storage / parking of machine (machine is idle)
Store the machine with the lid slightly open.
This allows the tank to dry out. As a result, the formation of mould and
unpleasant smells can be reduced.
We recommend disconnecting the plug from the mains socket
during storage / parking of the machine.
Service, maintenance and care
Caution:
Only TASKI branded spare parts must be used, otherwise
warranties and liabilities will be omitted!
The machine's maintenance is pre-condition for trouble-free running and a long
life.
Symbols:
◊ = after use, ◊◊ = every week, ◊◊◊ = every month
Activity
Drain and clean the foam solution tank
Clean the vent opening / filter
Clean the sinter bushing
Check the brush cylinder (e.g. wound up threads)
Wipe down the machine with a damp cloth
Service intervals
TASKI machines are built to the highest quality standards. This is supported by
internationally recognised quality control procedures. Electrical and mechanical
parts are subject to wear or aging if used for long periods of time.
• To maintain functional safety and operational rediness, a service must be
carried out after 300 working hours or at least once a year.
Under rough or extreme working conditions and / or insufficient maintenance,
shorter periods are necessary.
Service centre
Should you contact us due to a malfunction or for placing an order, please
always state the type, description and the serial number of your machine.
You can find this information on the name plate of your machine, and the
address of your nearest TASKI partner can be found on the last page of this
manual.
◊
◊◊ ◊◊◊ page
20
20
18
20
20
Advertisement
