Download Print this page

Stair Transportation; End Of Operation; Service, Maintenance And Care; Malfunctions - Taski aquamat 20 Manual

Hide thumbs Also See for aquamat 20:

Advertisement

Stair transportation

Caution:
The tank must be emptied before transporting over stairs!
Caution:
The fitted accessories must all be removed before transporting
over stairs!
Upwards:
Moving with the back of the machine to the stairs and with the
assistance of the running wheels, pull the machine upwards
step-by-step.
Dowwards:
Place the machine facing forward at the edge of the stairs and
slowly allow the machine to roll downwards step-by-step.
Caution:
Due to the weight of the machine, there are risks involved in such
transportation!
Slipping can result in damage to the machine and injuries to
persons.

End of operation

After brushing, the carpets should not be walked on again until they are
completely dry. Wherever possible, only replace the furniture when the carpet
is completely dry again. If this is not possible, protect the feet of the furniture
with aluminium foil (danger of rusting and staining).
Loosen the locking button for the recovery tank and remove the recovery tank.
Carefully clean the recovery tank with clean, warm water.
For draining, pull the corresponding hose out of its holder and
drain into the floor drain or a bucket.

Service, maintenance and care

Caution:
Only TASKI branded spare parts must be used, otherwise
warranties and liabilities will be omitted!
The machine's maintenance is a pre-condition for trouble-free running and a
long life.
Symbols:
◊ = after use, ◊◊ = every week, ◊◊◊ = every month
Activity
Drain and clean the foam solution tank
Clean the push-in filter with the closing cover for the
solution tank.
Check the suction foot and remove any soiling.
Check the function of the float and the dirt sieve, and
clean where necessary.
Wipe down the machine with a damp cloth
Service intervals
TASKI machines are built to the highest quality standards. This is supported by
internationally recognised quality control procedures. Electrical and mechanical
parts are subject to wear or aging if used for long periods of time.
• In order to maintain operational reliability and availability for use, the service
must be carried out after 500 working hours or at least once a year.
Shorter intervals may be necessary under rough or extreme working
conditions and/or in case of insufficient maintenance.
20
Service centre
Should you contact us due to a malfunction or for placing an order, please
always state the type, description and the serial number of your machine.
You can find this information on the name plate of your machine, and the
address of your nearest TASKI partner can be found on the last page of this
manual.

Malfunctions

Malfunction
Machine does not
run
No suction
Poor suction
Little or no water

Transport

The machine may only be transported after it has been emptied and is in a cold
state, normally in the standing position and sufficiently secured. The fitted
accessories must all be removed beforehand.
◊◊ ◊◊◊ page

Disposal

20
When they are no longer serviceable, the machine and its accessories must be
disposed of in a professional manner in accordance with the national
20
regulations. Your TASKI partner can help you here on request.
20
20
20
Possible causes
Troubleshooting
• Switch on the main
Main switch switched
switch
off
• Plug the power supply
No power supply
cord into the mains
socket
• Call for technical
Power cord defect
assistence
Main switch switched
• Switch on the main
off
switch
Motor protection
• Reset the trip fuse
switch has been
tripped
• Call for technical
Motor defective
assistance
Dirt in the suction foot • Clean
Cover not correctly
• Reposition
fitted
Seal defective or not
• Replace where
present
necessary
Suction hose torn or
• Replace or secure as
connection socket
required
loose
Recovery tank full/
• Switch off the suction
float has been
motor, and empty and
activated
clean the tank
Vent opening / filter
• Empty tank, then clean
blocked
the vent opening / filter
Pump switched off
• Turn on
Spray nozzles
• Dismount and clean
blocked
Spray nozzles dis-
• Remount or replace
mounted
• Empty the solution
Fresh water filter
tank, clean the tank
blocked
and the filter.
page
19
19
19
19

Advertisement

loading

This manual is also suitable for:

Aq 20