Error Code Failure System - Baumatic BWM1417W Instruction Manual

Error code failure system

If your appliance senses that it is not operating correctly, then an error
code may appear on the LED display.
The following error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR
POWER SUPPLY.
Display Reason
Inlet water
overtime.
Overtime of the
drainage.
The door has
not been
closed.
Voltage is too
high.
Others.
IF
GUARANTEE PERIOD AND FINDS THAT A FAULT
HAS BEEN CAUSED BY AN ITEM ON THE ERROR
CODE LIST, WHICH COULD HAVE BEEN CLEARED
BY THE CUSTOMER. THEN YOU MAY BE LIABLE
FOR THE COST OF THE SERVICE CALL.
ANY MAINTAINEANCE
Open the water tap to check if the inlet hose is
squashed or kinked. Check the filter in the inlet valve
is blocked or not. Check if the water pressure is too
low.
Check if the drain pump is blocked.
Check if the door of the washing machine is closed.
Check if the clothes are pinned by the door.
Check if the voltage is too high. If it is, you need to
add a constant voltage device.
Try again. Please contact the Customer Care Advice
Line is the problem persists.
If a fault code reappears after following the
above advice and clearing the fault code. You
should turn the washing machine off using
the POWER button. Disconnect the appliance
from your mains supply. Then arrange for an
engineer to attend the appliance. You should
contact the
Department on (0118) 933 6911.
AN ENGINEER
Solutions
Baumatic Customer
ATTENDS DURING
ON THE
Care
THE
33