Updating The System - Bosch DIP-5042EZ-0HD Installation Manual

DIVAR IP 5000
To replace hard disks:
1.
2.
3.
4.
5.
6.
7.
8.
9.
See also:
–
9.5

Updating the system

Following procedure describes how to update the system
manually.
To update DIVAR IP manually:
1.
2.
Bosch Sicherheitssysteme GmbH
Remove the defective hard disk. Use the handle to pull the
disk carrier out of the chassis.
Note: You can remove the hard disk during operation.
Turn off the unit by pressing the power button.
Insert the new hard disks into the chassis bay, making sure
that the drive carrier handle is completely closed.
Turn on the unit by pressing the power button.
Open DIVAR IP Dashboard with any browser. To do this, in
the address bar of the web browser, enter http://
mydivar/dlacockpit or http://<IP address of DIVAR
IP>/dlacockpit, then press ENTER. DIVAR IP 5000
Dashboard displays the message that you must open
Configuration > Disk management for configuration.
Click Configuration to open the configuration.
Expand System, then click Disk management.
To add the storage capacity of the hard disks to the system,
follow the instructions that are displayed.
After finishing the hard disk setup the individual disk status
LED to the right of the disk carrier will turn blue.
Chassis setup
In DIVAR IP Dashboard, click Device monitor in the tree
structure.
Click Update manually.
A dialog box is displayed where you can browse for the
update file.
Maintaining the system | en
2016.03 | V1 | DOC
29