Extending An Empty Unit; Replacing Hard Disks - Bosch DIP-5042EZ-0HD Installation Manual

28 en | Maintaining the system
4.
5.
6.
7.
8.
See also:
–
9.4.2

Extending an empty unit

You can extend an empty unit with additional hard disks.
To add hard disks to an empty unit:
1.
2.
3.
4.
See also:
–
–
9.4.3

Replacing hard disks

If a hard disk fails, the individual disk status LED to the right of
the disk carrier will turn red.
2016.03 | V1 | DOC
Open DIVAR IP Dashboard with any browser. To do this, in
the address bar of the web browser, enter http://
mydivar/dlacockpit or http://<IP address of DIVAR
IP>/dlacockpit, then press ENTER. DIVAR IP 5000
Dashboard displays the message that you must open
Configuration > Disk management for configuration.
Click Configuration to open the configuration.
Expand System, then click Disk management.
To add the storage capacity of the hard disks to the system,
follow the instructions that are displayed.
After finishing the hard disk setup the individual disk status
LED to the right of the disk carrier will turn blue.
Chassis setup
Insert the new hard disks into the chassis bay, making sure
that the drive carrier handle is completely closed.
Turn on the unit by pressing the power button.
The unit identifies the hard disks as new and starts the
recovery menu automatically.
After finishing the recovery process the DIVAR IP software
is installed. The individual disk status LED to the right of
the disk carrier will turn blue.
Perform a basic configuration using the configuration
wizard.
Chassis setup
Obtainging a basic configuration
DIVAR IP 5000
Bosch Sicherheitssysteme GmbH