Cisco SCH-7IN-TS-B/W Reference Manual page 13

Align and bend the wires carefully to fit them inside the Back Box.
Step 5
Align and carefully slide the power box into the Back Box.
Step 6
Secure the power box into the Back Box using the screws provided.
Step 7
Align and slide the back of the touchscreen into the power box. The touchscreen is magnetic and should
Step 8
snap into place easily.
(Optional) To secure the touchscreen inside the power box, remove the tape covering the bottom security
Step 9
pin (see
Power Over Ethernet (PoE) Connection
Connect the PoE Injector to power and the network, and then connect it to the power box.
The steps below describe how to install a PoE Injector.
Connect the PoE Injector to an AC outlet using the power cord.
Step 1
Connect one of the RJ-45 LAN ports on the gateway/router/switch to the PoE Injector's LAN port using
Step 2
the RJ-45 Ethernet cable.
Connect the PoE Injector's PWR LAN-OUT port to the RJ-45 Ethernet cable that will be connected to
Step 3
the touchscreen.
Pull the Ethernet cable through the top back hole of the Back Box to the Ethernet connector on the top
Step 4
back of the power box, and then connect it (see
Align and carefully slide the power box into the Back Box until the touchscreen is attached to the power
Step 5
box.
OL-27263-01
NOTE: Overtightening the power box screws could result in a poor connection between the
Note
touchscreen and the power box and could also cause the touchscreen to warp.
Figure 12) before attaching the touchscreen to the power box.
Figure 11).
Cisco Smart+Connected 7" In-wall Display Reference Guide
Power Installation
13