Power Installation - Cisco SCH-7IN-TS-B/W Reference Manual

Power Installation

Power Installation
Prepare the plastic power box for installation into the Back Box by inserting either the Ethernet cable or
the AC power cable into the power box (see
next.
AC Power Connection
The steps below represent a typical U.S. installation.
Connect the wires to the AC power source for the touchscreen according to the national and local
Step 1
electrical codes. Installation may require alternative wires and the use of a terminal block.
Thread the power cable through the bottom back hole of the Back Box to the terminal block (see
Step 2
Figure
Step 3 Strip the black and white power wire ends to 1/4" as necessary. Using a flathead screwdriver, loosen the
screws on the power box's terminal block and connect the power wires to each terminal (see
Cap the ground wire from the wall if you are using a plastic Back Box. Attach the ground wire to the
Step 4
Back Box if using a metal Back Box.
Figure 10
1
2
3
4
5
Cisco Smart+Connected 7" In-wall Display Reference Guide
12
10).
AC Power Connection
Power Box
Terminal Block
Connect Wires to Terminal Block
Back Box
Power Cable
Figure 10 and Figure 11), and then follow the instructions
Figure 10).
OL-27263-01