Cisco SCH-7IN-TS-B/W Reference Manual page 9

Smart+connected 7" in-wall display
Table of Contents

Advertisement

IMPORTANT! En coupant l'ouverture pour la boîte de mur, ne coupez pas l'ouverture trop grande.
Soyez conservateur et agrandissez-avec précaution la comme nécessaire.
IMPORTANT! When cutting the opening for the Back Box, DO NOT cut the opening too large. Be
Note
conservative and cautiously enlarge it as needed.
IMPORTANT! En coupant l'ouverture pour la boîte de mur, ne coupez pas l'ouverture trop grande.
Soyez conservateur et agrandissez-avec précaution la comme nécessaire.
Power and Network Installation Options
This device uses an Ethernet or Wi-Fi network connection, and can be powered using PoE or AC power.
Choose one of the following options to install the power and network communication.
Do not attempt to use PoE and AC power at the same time. Choose only one power option.
Caution
ATTENTION! Ne pas tenter d'utiliser PoE et AC en même temps. Choisir une seule option
d'alimentation.
Option 1: Ethernet Connection with a PoE Injector or a Third-Party Injector or Switch
PoE supplies DC power on the Ethernet cable using a a third-party PoE solution to provide the
touchscreen with power and a network connection. To set up your PoE and Ethernet connection with a
PoE Injector, see
Step 1
Attach the PoE Injector according to the instructions in your PoE's installation guide if provided.
Step 2
Pull the Ethernet cable from that location to where you want to install the touchscreen.
OL-27263-01
Figure
7.
Cisco Smart+Connected 7" In-wall Display Reference Guide
Installation
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents