Maintenance And Troubleshooting - Weslo Pursuit CT 2.4 User Manual

MAINTENANCE AND TROUBLESHOOTING

MAINTENANCE
Inspect and tighten all parts of the exercise bike
regularly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, replace the bat-
teries (see assembly step 11 on page 12); most
console problems are the result of low batteries.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, first turn the resistance knob
to the lowest setting.
Next, using an adjustable wrench, turn the left pedal
clockwise and remove it.
Then, see the EXPLODED DRAWING on page 23.
Remove the M4 x 50mm Screws (31) and the 3/16" x
3/4" Screws (32) from the Left and Right Shields (29,
30); note which size of Screw you remove from
each hole. Then, gently remove the Left Shield.
Locate the Reed Switch (7). Turn the Crank (3) until a
Magnet (12) is aligned with the Reed Switch.
7
12
25
Next, loosen, but do not remove, the two M4 x 10mm
Screws (25). Slide the Reed Switch (7) slightly closer
to or away from the Magnet (12). Then, retighten the
two Screws. Turn the Crank (3) for a moment.
Repeat these actions until the console displays correct
feedback. When the reed switch is correctly adjusted,
reattach the left shield and the left pedal.
17
3