Boundary Wire Basics; Pegging The Boundary Wire; Burying The Boundary Wire; Joining The Boundary Wire - Worx landroid Instruction Manual

4.

Boundary Wire Basics

4.1 Pegging the Boundary Wire

Use the Boundary Wire Distance Gauge (24) to set the correct
distance from the border of your lawn (More than 35cm *).
* This is the recommended distance. Use the provided distance
gauge to ensure proper installation.
®
If your neighbor also uses a Landroid M, then you must keep a
spacing of at least 2 metres between your Boundary Wire and your
neighbors.
®
Please be aware that your Landroid M will not be able to receive a
signal from the Boundary Wire beyond the distance of 18m.
H
The boundary wire must outline the intended mowing area
exactly. Your Landroid ®
M will become confused by extra bends or coils of Boundary Wire that are not part of its mowing
area ( See Fig. H). If there is excess Boundary Wire after the mowing area has been outlined, then cut it off and store
this additional wire in a separate location. However, it is important to leave the necessary length where it connects to the
Charging Base so it can be connected and still remain buried.

4.2 Burying the Boundary Wire

If you are planning to bury the Boundary Wire then it should be noted that when entering its Charging Base for the first time,
®
your Landroid M may find problems with the way you have laid the wire. It is recommended to first peg down the Boundary
®
Wire to the lawn so it is easy to make adjustments if necessary. This will allow the Landroid M to become adjusted to its new
environment and ensures it will successfully work with the charging base before the Boundary Wire is buried.
®
When you have completed installing the boundary wire, it is recommended that you ask Landroid M to follow the boundary
wire by pressing the home button.
®
Whilst observing Landroid M locating the charging station you can then make alterations to the boundary wire route to
®
ensure trouble free tracking of the boundary wire by Landroid M when locating the charging station.
11

4.3 Joining the Boundary Wire

The Boundary Wire (21) can be extended simply by splicing the ends
and connecting it to the ends of another piece of wire. You can use
insulating tape to secure the joined part of the wire. (See Fig. I)

4.4 Turn on and test installation

If the charger base LED does not come on, then check the power
connections.
If the charger base LED is flashing green, check if the boundary wire
is connected correctly.
Red light on: charging.
I
Red light flashing: error message, refer to Trouble Shooting and
correct the problems.
Green light flashing: check if the boundary wire is connected correctly.
® ®
When the green light on the charging base is on, place your Landroid M over the boundary wire, if Landroid M follows the
boundary it is connected correctly.
®
If your Landroid M is inside its territory but the display says "Outside working area" ,and the charger
base LED is green, it means you clamped the boundary wire ends incorrectly. Just reverse them.
Lawn Mowing Robot EN