How To Configure Your System - Cisco MX series Getting Started Manual

Cisco TelePresence Video Systems

Introduction Introduction

How to configure your system

Use a provisioning system, or configure
each video system individually
Provisioning allows video conferencing network administrators
to manage many video systems simultaneously. In general, you
only have to put in the credentials of the provisioning server
to each video system; the rest of the configuration is done
automatically.
Without a provisioning system, you must configure each video
system individually. To be able to make calls, you must set
the IP address, if not provided by the network, and SIP/H.323
parameters. You should also set the correct time and date.
Basic configuration with or without a provisioning system is
described in this guide.
D15318.02 Video Systems Getting Started Guide CE8.1, APRIL 2016.
User interfaces Web interface
User interfaces
The principal operating device for your Cisco TelePresence
video conference system is either a remote control or a Touch
controller. The remote control is not available for the MX series
or the SX80.
You can configure your system through its web interface, if the
system is already connected to a network and you know the IP
address. A limited set of configurations is also available on the
Touch controller and the on-screen menu.
We describe the web interface, the on-screen setup assistant
and the Touch controller in the following chapter.
On-screen setup assistant
Passphrase
Initially, no passphrase is set for the default
is mandatory to set a passphrase for any user with ADMIN
rights in order to restrict access to system configuration. This
includes the default admin user.
You can read more about how to set the passphrase in the
section
.
5
Getting Started Guide
Touch Appendices
admin
"Passphrase" on page 18.
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
user. It