During Use - Haier HLTD500ACW Service Manual

SERVICE MANUL
Model No.HLTD500ACW
10.Do not use heat to dry articles or products to eliminate static unless recommended
by the manufacturers of the fabric softener or product.
11.Clean lint screen before or after each load.
12.Keep area around the exhaust opening and adjacent surrounding areas free
from the accumulation of lint, dust and dirt.
13.Keep the dryer area clear and free from items that would obstruct the flow
of combustion and ventilation air through the louvered panel located on the rear
of the dryer.
14.The interior of the appliance and the exhaust duct should be cleaned periodically by
qualified service personnel.
15.Do not place items exposed to cooking oils in your dryer. Items contaminated with
cooking oil may contribute to a chemical reaction than could cause a load to catch fire.
16.If material has been used with any flammable liquids or solids, it dryer until all terraces
of flammable liquids should not used in the and its fumes have been removed.
17. This dryer must be properly installed in accordance with the installation instruction
before it is used. See grounding instructions in the installations sections.
18. Proper grounding must be ensured to reduce the risk of electric shock and force. Check
with a qualified electrician or service personnel if you are in doubt as to whether
the dryer is properly grounded.
19. Use the dryer only for its intended purpose: drying clothes.
20. Always disconnect dryer from electrical supply before attempting any service. Disconnect
power cord by grasping the plug, not the cord.
21. Replace worn power cord and/or loose plugs.
22. To reduce the risk of electric shock or fire, do not use extension cords or adapters to
connect dryer electrical power source.
3-2.

During Use

Exhaust system Requirements:
1. Do not use plastic flexible duct to exhaust the dryer. Excessive lint can build up
inside exhaust system and create a fire hazard and restrict air flow. Restricted
air flow will increase drying time. If your present system is made up of plastic
duct or metal foil duct, replace it with a rigid or flexible metal duct. Ensure
present duct is free of any lint prior to installing dryer duct.
- 7 -
Issue
Rev.