Haier HLTD500ACW Service Manual page 21

SERVICE MANUL
Model No.HLTD500ACW
A1. Remove the green ground screw connecting the neutral-ground jumper wire
white) to the cabinet and the center terminal block screw, then discard the
jumper wire.
A2. Attach the power cord ground wire (green) to the cabinet with the green ground
screw. Tighten the screw securely.
A3. Attach the power cord neutral wire (white) with the center terminal block screw.
Tighten the screw securely.
A4. Attach the remaining 2 power cord line wires (red and black) with the outer terminal
block screws. Attach one wire to each terminal block as shown. Tighten both screws
securely.
IMPORTANT:
PART B - 3-WIRE POWER CORD
A
B
C
A Ground Screw (Green)
Terminal Block Screw
B
C Neutral-Ground Jumper Wire
(White)
B1. Attach the power cord neutral wire (white) to the center terminal block screw.
Tighten the screw securely.
B2. Attach the remaining 2 power cord line wires (red and black) with the outer
terminal block screws. Attach one wire to each terminal block as shown.
Tighten both screws securely.
IMPORTANT:
Do not make a sharp bend or crimp the wires at connections.
D Power Cord Neutral Wire (White)
E
Power Cord Line Wires (One Red;
One Black)
F Power Cord
Do not make a sharp bend or crimp the wires at connections.
- 20 -
D
E
F
Issue
Rev.