Engine Oil; Oil Level Check - Honda NT700V Deauville Service Manual

MAINTENANCE
When checking the
clearance, slide the
feeler gauge from
the center toward
the outside.
Apply engine oil to
the lock nut threads
and seating sur-
face.
Check the valve clearances by inserting a feeler
gauge between the adjusting screw and valve stem.
VALVE CLEARANCES:
INTAKE: 0.15
+
0.02 mm (0.006
+
0.001 in)
adjusting screw until there is a slight drag on the
feeler gauge.
TOOLS:
Tappet lock wrench 07908-MB00100
Hold the adjusting screw and tighten the lock nut to
the specified torque.
TORQUE: 23 N.m (2.3 kgf-m, 17 Ibfmft)
After tightening the lock nut, recheck the valve
clearance.
timing and crankshaft hole cap grooves.
Apply engine oil to the timing and crankshaft hole
cap threads.
Install the timing hole cap and tighten it to the spec-
ified torque.
TORQUE: 10 N-m (1.0 kgfvm, 7 Ibf-ft)
Install the crankshaft hole cap and tighten i t to the
specified torque.
TORQUE: 15 M m (1.5 kgf-m, 11 Ibf4t)
Install the cylinder head cover (page 9-33].
ENGINE OIL
OIL LEVEL CHECK
Start the engine, and let it idle for 3
-
5 minutes.
Stop the engine and wait 2
-
3 minutes.
Hold the motorcycle in an upright position.
Remove the oil filler capldipstick and wipe the oil
from the dipstick with a clean cloth.
Insert the dipstick without screwing it in, remove i t
and check the oil level.