Channel Strip - PRESONUS FaderPort 8 Owner's Manual

6 Cubase / Nuendo (MCU)
6.2

Channel Strip

6.2 Channel Strip
1
2
3
4
5
6
7
8
Once you have connected your FaderPort 8 to your computer, launch Cubase
or Nuendo to set up the FaderPort 8 as a Mackie Control Universal device:
1. Go to Devices | Device Setup.
2. In the Setup window, click the "Add/Remove" menu.
3. Select 'Mackie Control' from the pull-down menu.
4. Set the MIDI Input and Output to "FaderPort 8. "
5. Click "Apply. "
6. Select MIDI Port Setup and make sure that "In All MIDI" box
is unchecked for the FaderPort 8 and then click "OK".
Your FaderPort 8 is now ready to use. Enjoy!
Power User Tip: For the best user experience, it is recommended that you select
compatibility mode for your FaderPort 8 from within Cubase.
1. Channel Name and Level. Displays the Channel name and current fader level.
2. Metering. Displays the channel metering. This can be turned on or off by
pressing SHIFT plus the push button encoder in the Session Navigator.
3. Pan Position. Displays the Channel's current pan position.
4. Pan/Param. This push-button encoder controls the pan of
the currently selected channel while in Track mode.
5. Select Button. This button selects the corresponding
channel in your DAW application. While selected, several
editing functions are available. See Section 6.2.2.
6. Solo. Isolates the corresponding channel's output signal in the mix.
7. Mute. Mutes the corresponding channel's output signal.
8. Touch-Sensitive Fader. This 100 mm motorized fader can be used to control
volume levels, aux send levels, panning, or plug-in parameters, depending on
mode. See Section 6.6 for more information.
FaderPort™ 8
Owner's Manual
33