Channel Strip; Select Button Modifiers - PRESONUS FaderPort 8 Owner's Manual

4 Logic (MCU)
4.2

Channel Strip

4.2 Channel Strip
1
2
3
4
5
6
7
8
4.2.1

Select Button Modifiers

Once you have connected your FaderPort 8 to your computer, launch
Logic to set up the FaderPort 8 as a Mackie Control Universal device:
1. Go to Logic Pro | Preferences | Control Surfaces | Setup...
2. In the Setup window, go to New | Install...
3. Select "Mackie Control" from the list of control surfaces
and click "Add". Close the device list window.
4. In the configuration menu to the left, set the Out Port to
"FaderPort 8" and the Input to "FaderPort 8. "
5. Close the Control Surface setup window.
Your FaderPort 8 is now ready to use. Enjoy!
1. Channel Name and Level. Displays the Channel name and current fader level.
2. Metering. Displays the channel metering. This can be turned on or off by
pressing SHIFT plus the push button encoder in the Session Navigator.
3. Pan Position. Displays the Channel's current pan position.
4. Pan/Param. This push-button encoder controls the pan of
the currently selected channel while in Track mode.
5. Select Button. This button selects the corresponding channel in Logic.
While selected, several editing functions are available. See Section 4.2.2.
6. Solo. Isolates the corresponding channel's output signal in the mix.
7. Mute. Mutes the corresponding channel's output signal.
8. Touch-Sensitive Fader. This 100 mm motorized fader can be used to control
volume levels, aux send levels, panning, or plug-in parameters, depending on
mode. See Section 4.6 for more information.
Arm. Pressing the Arm button will allow you to arm track for recording by pressing
the corresponding track's Select button.
Arm All. Press Shift + Arm to arm the eight currently focused tracks for recording.
FaderPort™ 8
Owner's Manual
20