Mix Management - PRESONUS FaderPort 8 Owner's Manual

4 Logic (MCU)
4.7

Mix Management

4.7 Mix Management
To engage Channel Focus, press Sends twice. In this mode, the
following four parameters are available for Send Slots 1 and 2:
• Send Destination. Use the Fader to select the Bus. Press the Pan/Param
encoder to commit the Bus selection. Fader 1 controls this parameter
for Insert Slot 1. Fader 5 controls this parameter for Insert Slot 2.
• Send Level. Use the Fader to control the Send level. Fader 2 control
Insert Slot 1's send level. Fader 6 controls Insert Slot 2's send level.
• Send Pre/Post selection. Use the Fader to switch between
pre- and post-fader send positions. Fader 3 sets this position for
Insert Slot 1. Fader 7 sets this position for Insert Slot 2.
• Send Active/Mute. Use Faders 4 and 8 to enable / disable
the send for Insert Slot 1 and 2 respectively.
1
2
3
4
5
1. Audio / Inputs. Press to view Audio tracks only. Press
Shift + Audio to view all Input channels.
2. VI. Press to view Instrument tracks only. MIDI view is not available in Logic.
3. Bus / Outputs. Press to view busses only. Press
Shift + Bus to view Output channels.
4. VCA / FX. There is no VCA view in Logic, however VCA's can be viewed when
either "All" or "Outputs" is active. Press Shift + VCA to view all Effects channels.
5. All / User. Press to view all channels. User view is not available in Logic.
FaderPort™ 8
Owner's Manual
25