Connecting To The Device - Siemens RUGGEDCOM i802 Installation Manual

RUGGEDCOM i802
Installation Guide
• Do not expose the microSD/microSDHC card to large magnetic or static electric fields.
• Do not bend or drop the microSD/microSDHC card.
CAUTION!
Security hazard – risk of unauthorized access and/or exploitation. Make sure to remove the microSD/
microSDHC card before decommissioning the device or sending the device to a third-party.
To insert or remove a microSD/microSDHC card, do the following:
1. Power down the device.
2. Unscrew the retention screw and remove the access plate.
Figure 6: Inserting/Removing a MicroSD/MicroSDHC Card
1. Retention Screw
3. Without touching the contacts on the card, insert or remove the microSD/microSDHC card.
4. Install the access plate and finger-tighten the retention screw.
5. Power up the device.
Section 2.5

Connecting to the Device

The following describes the various methods for accessing the ROS console and Web interfaces on the device.
For more detailed instructions, refer to the ROS User Guide for the RUGGEDCOM i802.
RS232 Console Port
Connect a PC or terminal directly to the RS232 console port to access the boot-time control and ROS interfaces.
The console port provides access to ROS's console and Web interfaces.
Connecting to the Device
2. Access Plate 3. MicroSD/MicroSDHC Card
1 2 3
Chapter 2
Installing the Device
9