IBM System x3850 X5 Implementation Manual page 551

IMM setting
You can change the CLI mode for the COM port for EMS. Use the following procedure:
1. Log in to the web interface of IMM.
2. Navigate to IMM Control  Serial Port.
3. Change the CLI mode to CLI with EMS compatible keystroke sequences (Figure 9-90).
Figure 9-90 Serial Redirect/CLI Settings
4. Click Save to save the changes.
For more information about Microsoft Emergency Messaging Service and the Special
Administration Console, see the following documents:
Boot Parameters to Enable EMS Redirection
http://msdn.microsoft.com/en-us/library/ff542282.aspx
Special Administration Console (SAC) and SAC commands
http://msdn.microsoft.com/en-us/library/cc785873
Windows Server 2003
Use the following procedure to enable the Microsoft Emergency Messaging Service and the
Special Administration Console. You must have administrator privileges.
1. Start a command prompt Start  Run  cmd.
2. Enter the command bootcfg.
Example 9-21 Output of the bootcfg command
C:\>bootcfg
Boot Loader Settings
--------------------
timeout:30
default:multi(0)disk(0)rdisk(0)partition(1)\WINDOWS
Boot Entries
------------
Boot entry ID: 1
OS Friendly Name: Windows Server 2003, Enterprise
Path: multi(0)disk(0)rdisk(0)partition(1)\WINDOWS
OS Load Options: /noexecute=optout /fastdetect
C:\>
3. Examine the output. If more than one boot entry exist, you must determine the default
entry.
4. Enable EMS with the bootcfg /ems on /port com2 /baud 115200 /id 1 command. In our
example, the default boot entry has the ID 1 (Example 9-22 on page 532).
Chapter 9. Management
531