IBM System x3850 X5 Implementation Manual page 440

Hide thumbs Also See for System x3850 X5:

Table of Contents

Figure 8-56 Editing the WMkernel settings in vSphere Client

4. Click OK.

5. Shut down the HX5.

6. Ensure that you have the latest FPGA code installed on the HX5 by updating it, if required.

7. Physically attach the MAX5 by using the instructions that are provided in the Installation

8. Reflash the FPGA code to ensure that both the HX5 FPGA code and MAX5 FPGA code

are at the same level.

9. After the FPGA code has been flashed, log in to the UEFI by pressing F1 at the UEFI

splash panel.

10.Select System Settings  Memory from the System Configuration and Boot

Management main menu.

11.Ensure that the MAX5 Memory Scaling option is set to Non-Pooled.

12.Continue to boot the server normally. Log in to the vSphere Client and check that the

additional memory shows on the Systems Summary tab.

Restoring ESXi to the factory defaults

You can use the IBM recovery CD to recover the IBM USB Memory Key to a factory-installed

state. Table 8-5 shows the available CDs.

Table 8-5 VMware ESXi recovery CD

IBM eX5 Implementation Guide

VMware ESXi 4.0 U1

VMware ESXi 4

VMware ESX Server 3i v 3.5 Update 5

VMware ESX Server 3i v 3.5 Update 4

Show Quick Links

Table of Contents

Troubleshooting