Storage/Winterization; Replacement Parts - Hayward PowerFlo Matrix Owner's Manual

Storage/Winterization

WARNING Explosion Hazard.
–
explode, with risk of severe injury or death to anyone nearby. Use only a low pressure (below 5 PSI),
high volume blower when air purging the pump, filter, or piping.
CAUTION
– Allowing the pump to freeze will void the warranty.
CAUTION
– Do NOT use anti-freeze solutions (except propylene glycol) in your pool/spa system.
Propylene glycol is non-toxic and will not damage plastic system components; other anti-freezes are
highly toxic and may damage plastic components in the system.
Gravity drain system as far as possible.
Storing Pump for Winterization
WARNING
– E
motor before draining pump.
Drain all water from pump and piping when expecting freezing temperatures or when storing pump.
1. Drain water level below all inlets to the pool.
2. Remove drain plug from bottom of strainer body.
3. Disconnect pump from base.
4. Once the pump is drained of water, re-install the strainer lid and strainer plug.
5. Store pump in a dry enclosure. Keep motor dry and covered during storage. To avoid
Start-Up for Winterized Equipment
1. Securely mount pump to base.
2. Install all intake and output fittings and piping.
3. Refill pool to proper water level.
4. Prime pump according to instructions.
Purging the system with compressed air can cause components to
H
, To avoid dangerous or fatal electrical shock hazard, turn OFF power to
LECTRICAL AZARD
condensation/corrosion problems, do NOT cover or wrap pump with plastic film or bags.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 7