Table of Contents
Advertisement
accordingly through the remote control.
Hint:
The settings for automatic image capturing, MMS
messages, etc., are deactivated when the camera is
switched to "TEST" mode.
3.4.1 Manual use
In TEST mode it is possible to capture pictures or videos
manually by pressing the
control.
Use the
Tbutton to stop the manual recording.
3.4.2 View images or videos
Press OK to enter image storage. Press
the previous image or
Please note:
Videos cannot be played on the LCD screen and only
thumbnails of the videos are shown. Detailed information
of operations like deleting images or videos is described
in the section "Advanced Operations".
3.4.3 Sending messages via MMS or by e-Mail
If the option "Manual" under menu point "Send mode" is
Tbutton on the remote
key to view
key for the next.
selected, images can be send to the set address. The
settings for "Daily report" and "Instant" under menu point
"Send mode" can only be used in the "ON" mode.
3.4.4 Switching off
Turn the power switch to the OFF position to switch the
camera off. Please note that even in the OFF mode,
the camera still consumes certain power at μA level.
Therefore, please remove the batteries if the camera will
not be used for a while.
4. Erweiterte Optionen
We know from the basic operations of the camera in
the previous chapter, that the camera has three basic
operational modes:
1. OFF mode:
Power switch is in OFF position
2. ON mode:
Power switch is in ON position
3. TEST mode:
Power switch is in ON position
and the remote control is
connected to the camera.
The OFF mode is a specific safety mode for replacing
the SD-card or batteries and transporting the camera.
GB
13
Advertisement
Table of Contents
