Setting The Controls; Changing The Bin Door Panel - Cornelius IACSSO Use And Care Manual

3. The water containing the rejected minerals is
drained after each freezing cycle.
4. Fresh water enters the machine for the next
freezing cycle.
5. Cubes fall into the storage bin. When the bin is
full, the ice maker shuts off automatically and
restarts when more ice is needed.
Setting the controls
NORMAL ON
THIN THICK OFF - - CLEAN
ICE CYCLE
1. Select an ice thickness. The ice maker has been
preset to produce ice approximately l/z" thick
while operating in a room temperature of 70°F
(21°C).
Operation in different room temperatures may
require readjusting the Ice Thickness Control
Knob toward "THICK" or "THIN."
Best operation will be obtained with ice I/Z" to 5/~"
thick.
If operating in a warm room temperature
(above 90°F (32°C)) DO NOT set Ice Thickness
Control Knob to maximum thickness. Doing so
could cause the unit to malfunction.
2. To start the normal freezing cycle, turn the Cycle
Control Knob to "ON."
3. To stop ice maker operation, turn the Cycle
Control Knob to "OFF."
The "CLEAN" setting is used whenever solutions
are circulated through the ice maker for
cleaning. Only the water pump operates at this
setting.
NORMAL
ON
THIN THICK OFF -
- CLEAN
ICE
CYCLE
Changing the bin door panel
You can make a decorative wood front to match
existing cabinets.
To change the bin door panel:
1. Open the storage bin door. Remove the two
screws holding the handle to the door frame.
2. Loosen the screws in both side trim pieces.
3. Remove the handle.