Appliance Cleaning Instructions - CVO Fire GEOMETRIX - CUBE Installation Manual

Once the pilot is lit, continue to hold the control knob in for 10-12 seconds. In this
time the pilot flame will heat the flame supervision thermocouple, operating a hold-on
magnet within the valve.
Next release the knob and turn anti-clockwise a further 90°. This will allow gas to
enter the burner at a low rate and be ignited by the pilot flame.
The appliance can now be set at any level between maximum and minimum by rotating
the control knob clockwise and anti-clockwise.
To turn off the main burner, press the control knob in and turn clockwise to the OFF
position.
Thus the sequence is:-
To light:
Step 1: From OFF press the control knob in and turn slowly anti-clockwise.
Step 2: Hold the knob in for 10 -12 seconds.
Step 3: Release knob and check pilot remains alight.
When the ignition click occurs check that the pilot is lit. (If not repeat 1 and 2).
Step 4: Turn knob anti-clockwise until the appliance ignites.
Step 5: Adjust flames to required level without pressing the knob.
To extinguish:
Step 1: Turn control knob clockwise to minimum position.
Step 2: Press knob in until able to continue turning clockwise to the OFF position.

6. Appliance Cleaning Instructions

Before any cleaning, ensure the appliance is switched off and has been given time to
cool down.
Matting :-
Due to the surface area and flatness of the ceramic burner matting, it is inevitable that
dust, debris from the chimney and combustion by-products will accumulate,
consequently the surface area of the burner unit should be cleaned at regular intervals.
The most effective method of dust/debris removal is achieved with the aid of a vacuum
cleaner however, great care must be taken to ensure that there is no contact between
the cleaner and the surface area of the burner unit, as damage to the matting will
result in the complete replacement of the matting panel. The replacement can only
take place in the factory. After ensuring that no damage has been done to the surface
the appliance is ready to re-ignite when ready.
5