. .
-.
•
DMM4040 and 4050
Safety and Installation Instructions
~
~
•
Connecting to Line Power
I
~
•
&&
Warning
To avoid shock hazard, connect the factory supplied three
~
•
conductor line power cord to a properly grounded power outlet.
I
Do not use a two-conductor adapter or extension cord, as this
~
•
will break the protective ground connection. If a two-conductor
I
power cord must be used, a protective grounding wire must be
e
•
connected between the ground terminal and earth ground
I
before connecting the power cord or operating the Meter.
e
•
I. Verify that the line
voltage selector
block is set to the correct
setting.
I
~
•
2. Verify that the correct fuse for the line
voltage
is installed.
I
~
I
3. Connect the power cord to a properly grounded three-prong outlet. Refer to Table
2 for descriptions of the line-power
cord types
available from Tektronix.
I
~
I
I
~
I
Table 2. Line-Power Cord Types Available from Tektronix
I
~
Type
Voltage I Current
Tektronix Part Number
North America
120 V /15 A
161-0066-00
North America
250V/10A
161-0066-12
Universal Euro
250 V /10 A
1 61-0066-09
United Kingdom
250 V /10 A
161-0066-10
Switzerland
250 V /10 A
161-0154-00
Australia
250 V /10 A
161-0066-13
Japan
125V 17A
161-0298-00
China
250V / 10A
161-0304-00
@I
~
~
~
~
~
~
•
Turning Power On
~
I. If required,
connect
the Meter to line power.
~
2. Toggle the power switch
on
the rear panel so the
"I" side
of the switch is
~
depressed. The Meter
will
tum on
and
briefly illuminate
all
LCD segments.
,
Note
To
save on
power consumption,
the
Meter
can
be
set
to
a
standby mode by
•
pressing
@
on the front panel. Press it again to bring the
Meter
up to full
power.
•
~
14