ETC Source Four Zoom Assembly Manual page 11

Figure 14
Figure 15
Figure 16
Source Four Zoom Assembly Guide
To remove a reflector
Tools required: Two spare reflector retainer clips (2).
1. Wedge one arm of a spare retainer clip between the lip of one of
the installed clips and the rim of the reflector, then slide the arm
down between the installed clip and the reflector as shown in
figure 14.
2. Insert the other arm of the spare clip between the other arm of
the installed clip and the reflector, as shown in figure 15.
Warning: Do not slide the spare clip all the way in or it will be
very difficult to remove...leave at least a quarter inch exposed.
3. Now slide the entire clip between the reflector and the installed
clip as shown in figure 16. Remember, do not slide it all the way
in.
4. Repeat this procedure with the second spare clip, inserting it
between an adjacent installed clip and the reflector.
5. Turn the reflector housing casting over, so that the rear of the
reflector is in view. Gently push on the reflector, toward the side
of the housing where the extra clips were placed. The reflector
will slip off to the side at an angle.
6. Turn the reflector housing casting back over and gently slide the
reflector out from under the retaining clips.
To install a reflector
Note: The following assumes all four reflector retainer clips (2) have
already been riveted to the reflector housing casting (1) and the gate
bushings (3) installed on the retainer clips.
1. Place the reflector housing casting (1) on a flat work surface
with the large opening facing up.
2. Install the reflector support spring (5) in the circular opening at
the base of the casting.
3. Insert the reflector (6) at an angle, under any three legs of the
reflector's clips.
4. Gently press down on the reflector until it snaps into place under
the clips.
Note: If the reflector does not snap in, turn the casting over.
Gently pull on the side of the reflector that has not snapped in
until the rest of the reflector slides into place.
To clean the reflector
Remove dust with a blast of oil-free air or wipe with a clean, lint-free
cloth using alcohol or distilled water (alcohol is recommended).
Warning: Do not use glass and window cleaners on the reflector.
Chemicals in these cleaners will stain the reflector.
11