Table of Contents
Advertisement
SECTION 13
ERROR CODE LIST CONT.
Error Number
Mag Verify Fail. Press Retry or Cancel to
19
Error Number
Mode Unsupported. Cannot print requested
20
image with this printer model. Please cancel
print job and adjust Driver settings to try again.
Error Number
CLEAN REQUIRED. Please clean the Rollers
21
Error Number
22
Ultra Electronics Card Systems
Displayed Error
continue.
Displayed Error
Displayed Error
to avoid deterioration
Displayed Error
Test Results
Rio Pro Maintenance Manual
Error Code
Error is shown while processing a "Magnetic Self Verify"
command from the Support Utility (e.g. a pre-encoded
Card is read back by the Printer and the results displayed
19:01
in the Support Utilty). If the data read back from the Card
cannot be determined the error is displayed (e.g. could
be in a Non-ISO format).
Error Code
Error can be shown while determining the format of the
downloaded print job. If colour printing has been
requested for the front of the Card but the Printer does not
20:00
support colour printing the error is displayed. Note that
this type of Printer does not yet exist and this feature is
reserved for future development.
Error is raised while determining the format of the
downloaded print job. If colour printing has been
requested for the back of the Card but the Printer does
20:01
not support colour printing the error is displayed. Note
that this type of Printer does not yet exist and this feature
is reserved for future development.
Error Code
Error can be shown if the cleaning prompt is enabled.
This prompt is displayed when the number of Cards
21:00
printed since the last clean exceeds the user configurable
threshold (by default 700). Note that this check is only
performed at Printer boot-up.
Error Code
Error is shown after executing a Sensor Test, initiated
22:00
using an SNS command. If the Printer found that the
Cam Sensor never changed then the error is displayed.
Error is shown after completing a Sensor Test, initiated
22:01
using an SNS command. If the Cam Sensor changed but
the Flip Sensor failed to unblock the error is displayed.
Error is shown after completing a Sensor test, initiated
22:02
using an SNS command. If the Cam Sensor changed but
the Flip Sensor never changed the error is displayed.
Error is raised after completing a Sensor Test, initiated
22:03
using an SNS command. If the Cam and Flip Sensors
both change the error is displayed.
- 74 -
Description of Problem
Description of Problem
Description of Problem
Description of Problem
Advertisement
Table of Contents
