Table of Contents
Advertisement
SECTION 13
ERROR CODE LIST CONT.
Error Number
Can‟t Lift Head, check Printer Mechanism
16
Error Number
Can‟t Drop Head, check Printer Mechanism
17
Error Number
Flipper Error, cannot initialise the Flipper.
18
Please clear Printer mechanism
Error Number
Mag Verify Fail. Press Retry or Cancel to
19
Ultra Electronics Card Systems
Displayed Error
Displayed Error
Displayed Error
Displayed Error
continue.
Rio Pro Maintenance Manual
Error Code
Error is shown while trying to lift the Print Head. If the
Cam Sensor does not block within 5 seconds the error is
16:08
displayed. By this point the Head has been lifted and the
Cam Sensor has just unblocked. The Printer is pulsing
the Cam Motor backwards to prevent overrun.
Error Code
Error is raised while trying to lower the Print Head. If the
Cam Sensor does not unblock within 5 seconds the error
17:00
is displayed. This function is called by the HEAD quick
command, the Cleaning routine and the Soak test routine.
Error is shown while lowering the Print Head and
analyzing the image data. If the Cam Sensor does not
unblock within 3 seconds this error is displayed. Note by
17:01
this point the image data has been completely analysed.
This function is used during the Printing routine before
starting to print each colour panel.
Error Code
Error is shown while trying to initialise the Flipper
mechanism. If the Flipper Position Sensor is not blocked
within 4 seconds the error is displayed. By this point the
18:00
Printer has already cleared any Card jam away from the
Flipper mechanism, if the front Sensor was found to be
blocked.
Error is shown while trying to initialise the Flip
mechanism. If the Flipper Position Sensor is not
unblocked within 4 seconds the error will be displayed.
18:01
By this point the Printer has already cleared any Cards
away from the Flipper mechanism if the Front Sensor was
found to be blocked. Also the Flipper Position Sensor has
been cleared (In other words, the Sensor is in the slot).
Error Code
Error is shown after carrying out the Magnetic Verification
cycle. If the data read back from the Card on the final
attempt does not match the data that was sent in the print
19:00
job the error is displayed. This error cannot occur if either
"Perform Verification" is switched off in the Printer
Settings or another error (e.g. Lid Open or Card Jam)
occurs during encoding/verification cycle.
- 73 -
Description of Problem
Description of Problem
Description of Problem
Description of Problem
Advertisement
Table of Contents
