Table of Contents
Advertisement
SECTION 13
ERROR CODE LIST CONT.
Error Number
06
Card Jam. Please clear Printer mechanism
Error Number
No Film detected. Please load a new roll of
07
Error Number
Out of Dye Film. Please load a new roll of
08
Ultra Electronics Card Systems
Displayed Error
Displayed Error
Film to continue.
Displayed Error
Film to continue.
Rio Pro Maintenance Manual
Error Code
Error is shown while feeding a Card from the Hopper into
the standby position (covering the middle Card Sensor). If
the front Sensor fails to block within 6 seconds the error is
06:22
displayed. By this point the Card has been successfully
taken from the rear Card Hopper and the Rio Pro is trying
to move it to the front Card Sensor, before returning it to
the standby position.
Error Code
Error is displayed while initialising the Dye Film. If the Rio
Pro cannot validate the electronic RFID Tag on the Dye
Film the error is displayed. Note that this RFID validation
07:00
process is not performed when no Tag is present the
printer assumes that a roll without a Tag is monochrome
(single colour ribbon). This error is only displayed when
the Tag is detected but invalid.
Error Code
Error is shown while trying to advance the Film to the start
of the next panel. If no Tacho Sensor pulses or Dye
08:00
Sensor transitions are seen for at least 5 seconds the
error is displayed.
Error is shown while trying to advance the Dye Film by a
certain fixed offset (for example, to line up the start of the
08:01
panel with the printing position). If no Tacho Sensor
pulses or Dye Sensor transitions are seen for at least 5
seconds the error will be displayed.
08:02
Error can be shown while running a Tacho Sensor test
(via the "TAC" quick command). If no Tacho Sensor
08:03
pulses are seen for at least 4 seconds an error will be
displayed.
Error can be seen while printing a colour panel. If no
Tacho Sensor pulses or Dye Sensor transitions are seen
08:04
for at least 150 printed lines (this equates to roughly
150ms) an error will be displayed.
Error can be seen during printing of the black panel. If no
Tacho Sensor pulses or Dye Sensor transitions are seen
08:05
for at least 150 printed lines (this equates to roughly
75ms) an error will be displayed.
- 67 -
Description of Problem
Description of Problem
Description of Problem
Advertisement
Table of Contents
