Table of Contents
Advertisement
SECTION 14.3
STATISTIC AND COMMANDS
This tab contains three separate areas:
Statistics
Shows information on Printer usage.
Quick Commands
Enables the user to send special commands to the Printer (usually used for fault diagnosis).
See table below.
Print *.PRN file
Enables the user to send previously saved print data to the Printer.
Quick Command
CAM
CHP
CLN
DYE
EJT
ENC
FEED
Ultra Electronics Card Systems
Function called upon receiving a
Print Head Cam Mechanism Position.
Function called upon receiving a
The function takes a single parameter (either UP or DOWN). If the parameter is DOWN, a Card is
fed into the Smart Encoding Unit. If the parameter is UP, the Card is moved to the standby position
(over the Middle Sensor).
Function is called upon receiving a
The function will cause the Printer to execute its Cleaning Cycle.
Function is called upon receiving a
The function re-initialises the Dye-Film.
Function is called upon receiving an
The function causes the Printer to eject a Card if there is one in the Print Engine.
Function is called upon receiving an
The function initiates the Magnetic Encoding Test Cycle.
Function is called upon receiving a
This function feeds a Card into the Standby Position (over the Middle Sensor). It takes a Single
Numeric Parameter: if this is Zero or One, the Card is left in the Standby Position, but if it is greater
than one it will eject the Card and feed another in, repeating however many times the parameter
specifies.
Rio Pro Maintenance Manual
- 82 -
Function
CAM
command. The function will cause the Printer to Reset the
CHP
command.
CLN
command.
DYE
command.
EJT
command.
ENC
command.
FEED
command.
Advertisement
Table of Contents
