Backside; Installation; Set Up And Operation - SHOWTEC SPECTRAL M850 Q4 TOUR Manual

Spectral M850 Q4 Tour

Backside

Fig. 02
04) 3-pin DMX signal connector OUT
05) 5-pin DMX signal connector OUT
06) Blue/White power connector 100-240V OUT
07) Safety eye
08) Blue/White power connector 100-240V IN
09) 3-pin DMX signal connector IN
10) 5-pin DMX signal connector IN
11) OLED display + menu buttons

Installation

Remove all packing materials from the Spectral M850 Q4 Tour. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Ordercode: 43620
8