Setting The Compander Mode; Using The Infrared Communication Function - Sony UTX-B03HR Operating Instructions Manual

6
Press and hold the POWER/MUTING button to turn
the power off, then press and hold the POWER/
MUTING button again to turn the power on.
Signal transmission starts.
Notes
• If there is no user input within 10 seconds after the
channel group display or channel number display starts
flashing, the displayed setting that is flashing is saved.
The same applies when setting other parameters.
• The frequency indicator changes in response to the
channel number.
• Do not remove the batteries while making settings. If
they are removed, re-insert them and repeat the
procedure from the beginning.
• Make sure that the same channel is set on transmitters
and receivers within the same system.

Setting the Compander Mode

Depending on the receiver being used in conjunction with
the unit, changing the compander mode may be
necessary.
Notes
• When operating in conjunction with UWP-D series
receivers, set the receivers to the same compander
mode.
• No audio will be output if the tone signal frequency is
different due to inconsistencies in compander mode
settings configured on the devices being used together.
• The compander mode can be configured when the menu
display is set to extended mode (page 10).
1
Use the + or – button to display the COMPANDER
menu.
2
Press and hold the SET button for 1 second or longer.
The selected item starts flashing.
3
Use the + or – button to select the compander mode,
then press the SET button.
The selected compander mode is configured.
UWP-D: Select this when operating in conjunction
with Sony UWP-D series receivers.
UWP: Select this when operating in conjunction with
Sony UWP series receivers.
WL800: Select this when operating in conjunction
with Sony WRR series receivers.
Receiver and compander mode
combinations
Configure the appropriate compander mode based on the
receivers being used.
Note
Audio will not be output if the combination of receivers
and compander mode settings are not correct.
Receiver
UWP-D Compander mode:
series UWP-D
(URX-P03,
Compander mode:
URX-S03D)
UWP
Compander mode:
WL800
UWP series (URX-P2, URX-M2)
WRR series (WRR-855S,
WRR-862, etc.)
Using the Infrared Communication
Function
When operating in conjunction with UWP-D series
receivers, the frequency and compander mode settings
configured on the receiver can be sent and applied to the
unit using the infrared communication function.
Note
This function cannot be used when operating in
conjunction with UWP or WRT series transmitters.
For details on the infrared communication function, refer
to the operating instructions supplied with the UWP-D
series receiver.
9
Compander mode on
unit
UWP-D UWP WL800
Yes No No
No Yes No
No No Yes
No Yes No
No No Yes