Sony UTX-B03HR Operating Instructions Manual page 12

ADVANCED: Displays all settings.
Setting the compander mode
(COMPANDER)
Set the operating mode of the compander.
UWP-D: High speech quality mode supported in
combination with UWP-D series devices.
UWP: Mode supported in combination with Sony UWP-
series receivers.
WL800: Mode supported in combination with Sony 800-
series receivers.
Notes
• This function is displayed in extended mode only.
• No audio is output if the tone signal frequency is
different due to the use of a combination of devices with
different compander mode settings.
Locking the POWER/MUTING button
(PWR LOCK)
Lock the POWER/MUTING button to prevent the power
being turned off inadvertently during transmission.
UNLOCK: Press and hold the POWER/MUTING button
to turn the power on/off.
LOCK: The power does not turn off, even after pressing
the POWER/MUTING button.
To release the lock state
To release the lock state, either set the PWR LOCK menu
to UNLOCK or use the following procedure.
1
When the button is in the LOCK state, press and hold
the POWER/MUTING button.
A prompt appears asking you whether to release the
lock state.
2
Use the + or – button to select YES, then press the
SET button.
The lock state is released.
Notes
• This function is displayed in extended mode only.
• The POWER/MUTING button lock state does not
change after switching to simple mode after setting the
button to LOCK in extended mode.
• If the batteries are removed and reinserted while the
POWER/MUTING button is set to LOCK, the power
will turn on automatically but the lock state of the
POWER/MUTING button does not change.
Muting the output (MUTING)
Pressing the POWER/MUTING button while
transmitting mutes the audio so that audio from the
receiver is not output.
Pressing the POWER/MUTING button again restores the
audio output.
ENABLE: Pressing the POWER/MUTING button mutes
the output.
DISABLE: The output is not muted even when the
POWER/MUTING button is pressed.
Notes
• This function is displayed in extended mode only.
• In muting, the audio signal is not output but an RF
signal is still transmitted.
Switching the phase of the microphone
(PHASE)
Depending on the model of the connected microphone,
change the phase setting.
NORMAL: Phase is not reversed.
INVERT: Reverses the phase within the transmitter. Set
to INVERT when an EC-1.5CF is connected.
Note
This function is displayed in extended mode only.
Setting the battery type (BATTERY)
Set the type of battery being used in order to provide a
more accurate battery level indication.
TYPE1: Recommended setting when using alkaline LR6
(size AA) batteries. Indicates the battery level based on
the characteristics of new Sony alkaline LR6 (size AA)
batteries.
TYPE2: Recommended setting when using rechargeable
nickel metal hydride batteries.
TYPE3: Recommended setting when using lithium
batteries.
Notes
• This function is displayed in extended mode only.
• The characteristics of batteries change according to
battery type and environmental conditions. It is
recommended that you understand the characteristics of
batteries before using them.
Setting the display contrast (CONTRAST)
Adjust the contrast of text and icons on the display in the
range 1 to 10.
The configurable values are given below.
(Light) 1 2 3 4 5 6 7 8 9 10 (Dark)
Note
This function is displayed in extended mode only.
Restoring factory default settings
(RESET)
Restore all parameters to their factory default settings.
Press and hold the SET button. A prompt appears asking
you whether to restore factory default settings. Press the
12