Table of Contents
Advertisement
For details on wireless remote control function, see
"Using Cross Remote" (page 8).
Setting the battery type
TYPE)
Set this item according to the type of batteries you use to
obtain accurate battery power status indication.
TYPE1: Select this when using AA alkaline batteries. The
battery level status is indicated based on the characteristics
of new LR6 (size AA) alkaline batteries from a specific
manufacturer.
TYPE2: Select this when using rechargeable nickel-metal
hydride batteries with capacities of about 2000 mAh.
TYPE3: Select this when using lithium batteries.
TYPE4: Select this when using rechargeable nickel-metal
hydride batteries with capacities of about 2500 mAh.
Notes
• The characteristics of batteries change according to
battery type and environmental conditions. It is
recommended that you learn the characteristics of
batteries you use before using them.
• Rechargeable AA lithium-ion batteries cannot be used.
Cross Remote
(RF REMOTE)
Enable use of the wireless remote control function between
the unit and the receiver that will be used with the unit.
OFF: Disables the wireless remote control function.
ON: Enables use of the wireless remote control function
with the paired device.
PAIRING: Executes a new pairing.
For details, see "Pairing with a receiver" (page 8).
Receiver search function
Use this function to quickly locate a receiver
communicating on the same frequency as the unit.
When the receiver is found, the receiver will react (e.g., the
receiver's display will blink).
Note
If a receiver does not support the receiver search function,
it will not react.
For details on receiver actions, refer to the receiver's
operating instructions.
Searching for receivers
Hold down the SET button in the SEARCH RX screen,
and press the SET button again while the "SEARCH?
YES" display is blinking.
You can hold down both the + button and – button for 1
second or more at the same time to start the receiver search
function.
(BATTERY
(SEARCH RX)
12
Audio codec mode setting
MODE)
MODE1: Audio codec mode that is compatible with first
generation DWX-series devices.
MODE2: Audio codec mode that prioritizes short delay
times while maintaining transmission stability and high
audio quality.
MODE3: Audio codec mode that uses additional signal
processing to suppress noise caused by unexpected pulse
interference.
MODE4: Audio codec mode that prioritizes audio quality
for faithful reproduction while maintaining transmission
stability and low delay time.
Under normal circumstances, we recommend using
MODE2 (prioritizing delay times) or MODE4 (prioritizing
audio quality).
However, use MODE1 when when using the unit in
conjunction with first generation DWX-series devices, and
use MODE3 in environments where unexpected pulse
interference may occur.
The audio delay durations that occur when transmitting
and receiving with each mode will vary depending on the
receiver's operating environment. For details, refer to the
receiver's operating instructions.
The audio codec mode setting can be changed from the
receiver and other devices via the wireless remote control
function.
For details, see "Using Cross Remote" (page 8).
Encrypted transmission function
Setting
(ENCRYPTION)
Enable the encrypted transmission function.
SECURE KEY: Enables the encryption key mode that is
compatible with first and second generation DWX-series
devices.
AES256: Enables the AES256 encryption key mode.
PASSWORD: Enables the password mode.
OFF: Disables the encrypted transmission function.
For details, see "Using the Encrypted Transmission
Function" (page 9).
Audio input level setting
Set the input level to the analog head amp.
Select LINE or MIC according to the audio source
connected to the audio input connector.
The factory setting is MIC.
The MIC/LINE setting for the audio input level can be
changed from the receiver and other devices via the
wireless remote control function.
(CODEC
(INPUT LEVEL)
Advertisement
Table of Contents
