Settings; Entering Setting Mode; Setting The Transmission Channel - Sony WRT-8P Operating Instructions Manual

Settings

Notes
• The transmitter cannot transmit in setting
mode.
• Make sure that the channel selected on
the transmitter is the same as that selected
on the tuner being used in the same
system.
• Depending on the noise or interference
conditions, all selectable channels may
not be usable. If necessary, you can
determine usable channels by cycling the
channel selection through a number of
channels on the tuner with the transmitter
set to OFF. Those channels for which the
RF indicator on the tuner does not light
are usable.
• If there is a TV broadcasting station
nearby, do not use the station's channel.
• The transmitter may not operate correctly
if it is turned on immediately after being
turned off in setting mode. Wait for a few
seconds before turning the power on
again.
• The channel numbers and frequencies of
your transmitter are shown on the "Sony
Wireless Microphone System Frequency
List" supplied with this Operating
Instructions.

Entering setting mode

In setting mode, you can change the
transmission channel or frequency and RF
output power setting. You can also reset the
accumulated battery use time indication or
turn on/off the +48 V power supply for the
connected microphone.
To enter setting mode
Turn on the transmitter while pressing
down the SET button.
The transmitter enters setting mode and the
parameters that were displayed when the
unit was last turned off start to flash.
Each time you press the SET button, the
setting items are cyclically switched as
shown below.
Transmission
channnel
Transmission
frequency
Accumulated
battery use
time
RF output
power setting
Input signal
setting
Channel/frequency indications show
those of the U66 model.
Setting the transmission
channel
The transmission channel can be selected
through either the channel number or the
frequency.
1
Set the transmitter to the setting mode.
2
Press the SET button repeatedly until
the channel number (or frequency)
indication appears.
3
Press the + or – button to select the
channel number (or frequency).
Press
the SET
button.
Settings 9