Settings; Initiating Setting Mode; Changing The Transmitting Channel - Sony WRT-822A Operating Instructions Manual

Settings

Initiating Setting Mode

In Setting mode, you can change the transmission channel/
frequency and the attenuation level, or reset the accumulated
time indication.
To enter Setting mode
While holding down the SET button, set the POWER switch
to ON.
The transmitter enters Setting mode and the indication
before the transmitter was previously turned OFF flashes on
the display section.
Each time you press the SET button, the setting items are
cyclically switched as shown below.
Channel selection
Accumulated time
indication reset
Frequency selection
Attenuator adjustment

Changing the Transmitting Channel

1
Confirm that the channel number flashes on the display.
If not, set the unit in Setting mode, and press the SET
button so that the channel number flashes.
If you want to change the channel in frequency
indication, press the SET button one more.
In channel selection mode
In frequency selection
mode
2
Press the + or – button to select the channel.
Pressing the + button cyclically changes the channel
indication in the order shown on page 6.
Pressing the – button changes it in reversed order.
If you keep either button pressed, the channel number
will be incremented or decremented successively.
11