Error Messages - Sony UTX-B03HR Operating Instructions Manual

+ or – button to select YES, then press the SET button.
The transmitter parameters are restored to their factory
default settings.
Notes
• This function can be used in transmission stopped mode
only.
• After a reset, the audio input level is also restored to its
factory default setting. Note that this may cause the
volume on devices connected to the receiver and in
headphones to suddenly change.
Displaying the software version
(VERSION)
Display the software version of the transmitter.
Note
This function is displayed in extended mode only.

Error Messages

When a problem occurs, one of the following error
messages may appear on the display.
Message Meaning
EEP An error has
ERROR occurred in the
backup memory
data.
PLL ERROR An error occurred in
the PLL synthesizer
circuit.
13
Solution
Contact your Sony
service representative.
Restart the unit. If the
message persists,
contact your Sony
service representative.