Notes On Microphone System Operation; Settings; Initiating Setting Mode - Sony WRT-805A Operating Instructions Manual

Notes on Microphone
System Operation
•
To operate with 2 or more channels, maintain a distance of
at least 30 cm (1 ft.) between each pair of transmitters.
For details of operation with 2 or more channels, refer to
the Operating Instructions for the WRR-800A/801A/850A
UHF Synthesized Diversity Tuners.
•
Ensure that the tuners set to channels not being used are
either turned off or set to the minimum output level.
•
When powering the transmitter on or off, to keep the noise
to a minimum, set the audio output level from the tuner or
mixer to a minimum.
•
Powering the transmitter on without checking the channel
selection first may interfere with the operation of other
microphones/transmitters, if the current setting is already
being used.
•
Separate the reception antennas and the transmitter by more
than 3 meters (10 ft.).

Settings

Initiating Setting Mode

In Setting mode, you can change the transmission channel
and the attenuation level, or reset the accumulated time
indication.
To enter Setting mode
While holding down the SET button, set the POWER switch
to ON.
Hold the SET button down until a display appears on the
liquid-crystal display.
The transmitter enters Setting mode and the indication
before the transmitter was previously turned OFF flashes on
the liquid-crystal display.
Each time you press the SET button, Channel selection
mode, Attenuator adjustment mode (page 13) and
Accumulated time indication reset mode (page 14) are
cyclically switched.
Attenuator
Channel selection
adjustment
CH
Press the SET button.
Accumlated time
indication reset
CH CH
11