Oil Replacement - Malaguti f10 Service Manual

OIL REPLACEMENT

(wheel shafts)
• With the shaft blocked in a clamp,
in vertical position, place a
container beneath the screw (V).
• V -
• Let the oil flow for a few minutes.
• Remove the wheel shaft as
described above.
• Turn the shaft upside down and let
any residual oil drip out.
Do not disperse oil in the
environment. Make sure it is
eliminated according to local
norms regarding special
garbage disposal.
• Tighten the screw (V) with its
relative gasket.
• Carefully pour new oil in the shaft:
~ 50 cc (right - left)
• Check oil level as described
above.
• Reassemble the parts..
Cs - N * m
V
24 ± 10 %
F.55
FORK ASSY
To remove the complete fork, remove:
• Shield (p. 13).
• Front wheel (p. 25).
• Odometer return.
• Brake caliper (p. 26).
• Handlebar (p. 24).
To release the fork:
• Ring nut (A).
Replace the fork (A) to prevent falling.
Cs - N * m
A
140 ± 20 %
NOTE -While removing the fork group, be careful not to let the
balls (S) out.
• Clean the cap seats (C). Check them for wear and replace
them if necessary.
Grease and reassemble the fork unit.
Upper balls 22 (Ø 3/16")
Lower balls 22 (Ø 3/16")
28 03/08
F.56
F.57