Download Print this page

Serial Communications Protocol - Barco F(L)35 Command Reference Manual

Hide thumbs Also See for F(L)35:

Advertisement

2. COMMUNICATION PROTOCOL DEFINITIONS
About
This section describes the definitions used in the communications protocol. When the projectors are connected to either RS232 or
LAN you can control the projectors through this ASCII based protocol.
Some commands will generate OSD feedback. This can be stopped by turning off the OSD from the projector's
menu system or by setting "OSDC" to value 0 (OSD off) or value 1 (OSD show only warnings).
Overview
Timing

Serial Communications Protocol

Examples
2.1
Timing
General timing constraints
Behavior
Power on (wake from standby) At least 30 seconds wait after power up complete before sending next command
Command
No response received
Between commands
After sending 20 commands
2.2
Serial Communications Protocol
Definitions
Like every communication method the serial communication uses a particular protocol (ANSI) which must be respected in order to
allow communication to take place.
The header is ASCII colon ':' character.
Use of a separator is optional in the command protocol. The protocol accepts one ASCII SPACE between fields, or no ASCII SPACE
between fields.
All acknowledgement protocol use an ASCII SPACE (single) as a separator.
The terminator is ASCII value carriage return (CR)/hex value 0x0D.
The following table gives a summary of the predefined communication terms.
Header
Limitations
1 byte
Definition
ASCII colon :
Example
:
Header
The header informs the projector (in case of transmission) or the computer (in case of reception) that a new data transfer will take
place.
Message body
The message body defines the action to be performed. The message body is built up of several fields:
601–0381–00 F(L)35, FS35 IR, F85 21/10/2015
Constraint
Response required before sending next command
At least 2 seconds before re-sending if no response received
Minimum 500 ms delay required between commands
Minimum 5 seconds delay required
Message body
N bytes
Mnemonic Modifier Value Target
POWR1
2. Communication protocol definitions
Terminator
1 byte
Carriage Return (Hex 0x0D)
CR
3

Advertisement

loading

This manual is also suitable for:

Fs35 irF85