Table of Contents
Advertisement
8.4
SUGGESTED MOUNTING DISTANCE FOR COMFORT*
Since most installations will differ in many details, these instructions are general. Sound judgment
must be exercised and careful supervision is essential to ensure the installation will be made in the
best manner possible for trouble-free operation and at minimal cost. All systems must be installed in
accordance with acceptable practices, local codes, and applicable standards.
This heater is suitable for reflector mounting angles up to 30 degrees on the short axis. Improper an-
gle mounting can result in overheating of controls and combustible materials.
IMPORTANT: For either horizontal or angle mounting, the long axis of the heater must be level.
Use only non-combustible mounting hardware.
NOTE: It is the responsibility of the installer to insure that the chosen suspension system will sup-
port at least 200 lbs.
8.5 HORIZONTAL suggested mounting distance for comfort.*
ecoSchwank / IL
Distance to floor
Maximum heater spacing
Maximum distance between heater rows
8.6 ANGLE suggested mounting distance for comfort.*
ecoSchwank / IL
Distance to floor
Maximum heater spacing
Maximum distance between heater rows
* These mounting distances are suggested and are subject to site conditions. If in doubt, please
contact your Schwank distributor.
MOUNTING HEIGHTS:
6 / 25
10 / 37
12'
16'
25'
6 / 25
10 / 37
12'
16'
25'
Page 9
13/ 50
18 / 75
16'
20'
22'
28'
30'
40'
13 / 50
18 / 75
13'
17'
22'
28'
30'
40'
26 / 100
24'
28'
34'
39'
50'
70'
26 / 100
20'
22'
34'
39'
50'
70'
GP-MECX-CX-1A
eco-X / IL-X Manual
RD: SEPT 2005
RL: 1A
BA
Advertisement
Table of Contents
