Table of Contents
Advertisement
9.6
SUGGESTED MOUNTING DISTANCE FOR COMFORT**
Since most installations will differ in many de-
tails, these instructions are general. Sound judg-
ment must be exercised and careful supervision is
essential to assure the installation will be made in
the best manner possible for trouble-free opera-
tion and at minimal cost. All systems must be
done in accordance with acceptable practices, lo-
cal codes, and applicable standards.
This heater is suitable for reflector mounting an-
0
gles up to 30
degrees along the short axis
*Reflector with venturi must be in upper position
HORIZONTAL suggested mounting distance for comfort.*
ecoSchwank
Distance to floor
Maximum heater spacing
Maximum distance between heater rows
ANGLE suggested mounting distance for comfort.*
ecoSchwank
Distance to floor
Maximum heater spacing
Maximum distance between heater rows
** These mounting distances are suggested and are subject to on sight conditions. If in doubt, please
contact your Schwank distributor.
Improper angle mounting can result in overheat-
ing of controls and combustible materials.
IMPORTANT:
mounting, the long axis of the heater must be
level. Use only non-combustible mounting
hardware.
NOTE: It is the responsibility of the installer to
insure that the chosen suspension system will sup-
port at least 200 lbs.
MOUNTING HEIGHTS:
6
12'
16'
25'
6
12'
16'
25'
Page 10
For either horizontal or angle
10
13
16'
20'
22'
28'
30'
40'
10
13
13'
17'
22'
28'
30'
40'
18
26
24'
28'
34'
39'
50'
70'
18
26
20'
22'
34'
39'
50'
70'
SP-MECM-BX-05A
ecoSchwank - Millivolt Manual
RD: MAY, 2004
RL: 5
KH
Advertisement
Table of Contents
