FRONT AND REAR BRAKES
Be careful that water does not enter the
brake master cylinder when refilling.
Water will significantly lower the boiling
point of the brake fluid and may result in
vapor lock.
4.Air bleed:
Brake system
Refer to "AIR BLEEDING (HYDRAULIC
BRAKE SYSTEM)" in CHAPTER 3.
5.Inspect:
Brake fluid level
Brake fluid level is under the "LOWER"
level line → Fill up.
Refer to "BRAKE FLUID LEVEL INSPEC-
TION" in CHAPTER 3.
REAR BRAKE MASTER CYLINDER
INSTALLATION
1.Install:
Copper washers 1
Brake hose 2
Union bolt 3
CAUTION:
When installing the brake hose onto the
brake master cylinder, make sure the brake
pipe touches the projection a as shown.
WARNING
Proper brake hose routing is essential to
insure safe machine operation. Refer to
"CABLE ROUTING".
8 - 20
CHAS
New
30 Nm (3.0 m • kg, 22 ft • lb)