Å
ı
CRANKCASE
OIL PUMP DRIVE GEAR REMOVAL
1.Straighten:
Lock washer tab
2.Remove:
Oil pump drive gear nut
*********************************
Removal steps:
Temporaly
assembly 1.
Hold the clutch carrier assembly with a
clutch holding tool 2 and loosen the oil
pump drive gear nut.
Clutch holding tool:
P/N. YM-91042, 90890-04086
Remove the clutch carrier assembly.
*********************************
CRANKCASE SEPARATION
1.Separate:
Left crankcase
Right crankcase
*********************************
Separation steps:
Remove the crankcase bolts.
NOTE:
Loosen each bolt 1/4 of a turn at a time
and after all the bolts are loosened,
remove them.
Loosen the bolts in stages, using a criss-
cross pattern.
Å Left crankcase
ı Right crankcase
4 - 60
ENG
install
the
clutch
carrier